![]() REPEAT Steps 9-11 to program any additional smart key transmitters. ![]() The DIC will again say “READY FOR REMOTE #1.” WAIT 10 minutes until the DIC displays “PRESS ENGINE START BUTTON TO LEARN.” The DIC will again say “REMOTE LEARN PENDING, PLEASE WAIT.” WAIT 10 minutes until the DIC displays “PRESS START BUTTON TO LEARN.” The Driver Information Console (DIC) will display “REMOTE LEARN PENDING, PLEASE WAIT.” INSERT the CUT emergency key of the NEW smart key fob into the key lock cylinder AND TURN the key counterclockwise to the UNLOCK position 5 times within 10 seconds. ![]() SMART PROXIMITY KEY FOB REMOTE - WITHOUT PROGRAMMED REMOTE Step-By-Step How To Programming Instructions WHEN all additional smart key transmitters have been programmed, PRESS and HOLD the ENGINE START/STOP button for 12 seconds to EXIT Programming Mode. REPEAT Steps 4-6 to program any additional smart key transmitters. REMOVE the smart key fob from the Transmitter Pocket and PRESS the LOCK or UNLOCK button to finalize programming of the remote. When the smart key is learned, the DIC will display “READY for REMOTE #N.” PLACE the new smart key into the Transmitter Pocket (refer to Owner’s Manual for location). REMOVE the top tray and the rubber mat inside of the center console storage area. The Driver Information Console (DIC) will display “READY FOR REMOTE #3, 4, or 5.” Insert the door key into the slot on the bottom of the cover. REMOVE the key lock cylinder cap (located on the outside of the Driver’s door to the right of the door handle). PLACE the 2 programmed smart keys in the cupholder. SMART PROXIMITY KEY FOB REMOTE - WITH TWO PROGRAMMED REMOTES Step-By-Step How To Programming Instructions Canadian regulations require that Owners see their Dealer for this service, IF they have NO programmed remotes available for their vehicle.You can program any remaining flip keys using the “Programming WITH TWO Programmed Flip Keys” procedure above. TURN the Ignition to OFF/LOCK and REMOVE it to EXIT Programming Mode. TURN the Ignition to ON/RUN to finalize successful programming of the flip key. TURN Ignition to the ON/RUN position (just shy of cranking engine). TURN the Ignition to the OFF/LOCK position. WAIT 10 minutes until the security light turns OFF. The security light will turn on to indicate successful entry into Programming Mode. INSERT the NEW flip key into the Ignition. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |